Wash the body to ensure that there is no dust, dirt or grime left behind that might end up blotching the paint job. Be careful not to disturb the markings made by the marker. Once the paint design has been drawn, wash the body lid with some hand soap.
A tape measure or some specific pattern can be used if you are vying for a symmetric design to make sure that the design lands up at the right places. Asymmetrical means that the design will be different all around. Symmetrical implies that the design on one side is repeated on the other as well. Your paint job design can be either symmetric or asymmetric. In case of any mistake, you can always remove the undesired lines with a small cloth sprayed with little alcohol. For example, if you want to construct a circle, you can grab a duct tape roll and use it to draw a circular shape. You can use various tools if you are attempting a rather complicated design. It is judicious to have the paint design in mind before you actually apply the blueprint for new paint scheme to the body lid.
As the paint dries, you will be able to peel this veneer off with no marker residue left behind under the paint. You can still mark the mounting holes that you drilled earlier with the help of a marker since there is an invisible paint screen on the body lid. It is time for you to sketch your paint design. Now, the body has been trimmed and mounting holes have been drilled where required to ensure that the lid fits snug onto the RC car chassis. It is suggested that you use curved bi-scissors to make smooth cuts with no undesired edges that might trouble you later on. By trimming the body to the car specifications and modifying it, you will ensure that the paint finish is smooth and without any scuff marks that will need repainting. This will help you out in the subsequent steps and will prevent you from spoiling the paint. Identify the areas that need to be trimmed or drilled and mark them with a marker so that you can drill them later for mounting purposes. Buy Now Trim the body to paint RC car body specificationsįirstly, place the body lid that is about to get painted on the car chassis just to see if the lid fits properly on it.
0 kommentar(er)
